XEROX CORP -- TONER CARTRIDGE, 6R424  -- 6850-00N034423
<pre>=====================  Product Identification  =====================

Product ID:TONER CARTRIDGE, 6R424
MSDS Date:08/02/1990
FSC:6850
NIIN:00N034423
=== Responsible Party ===
Company Name:XEROX CORP
Address:100 CLINTON AVE S
City:ROCHESTER
State:NY
ZIP:14644
Country:US
Info Phone Num:800-828-6571
Emergency Phone Num:716-422-2177
CAGE:0E6G9
=== Contractor Identification ===
Company Name:XEROX CORP
Address:300 MAIN ST NO 27C
City:EAST ROCHESTER
State:NY
ZIP:14645
Country:US
Phone:800-828-6571; 800-351-2024
CAGE:0E6G9
Company Name:XEROX CORPORATION
Address:100 CLINTON AVE SOUTH
Box:City:ROCHESTER
State:NY
ZIP:14644-1877
Country:US
Phone:800-828-6571/716-422-2177
CAGE:26921

=============  Composition/Information on Ingredients  =============

Ingred Name:IRON OXIDE
CAS:1317-61-9
Fraction by Wt: 45-55%
OSHA PEL:10 MG/M3 (FE)
ACGIH TLV:5 MG/M3 (FE)

Ingred Name:STYRENE-ACRYLATE RESIN; (STYRENE/ACRYLATE POLYMER)
CAS:25767-47-9
Fraction by Wt: 40-45%

Ingred Name:PROPENE, POLYMERS; (POLYOLEFIN)
CAS:9003-07-4
RTECS #:UD1842000
Fraction by Wt: <5%

Ingred Name:SILICA DIOXIDE AMORPHOUS; (AMORPHOUS SILICA GEL)
CAS:7631-86-9
Fraction by Wt: <2%

Ingred Name:DYE (CHROMIUM/AZO DYE COMPLEX)(OTHER MFR CAS NO:
    109125-50-0, 109125-51-1)
CAS:84179-66-8
Fraction by Wt: <1%

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:LD50: (ORAL,RAT) >5 G/KG
Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:MIN RESP TRACT IRRIT MAY OCCUR AS
    W/EXPOS TO LRG AMTS OF ANY NON-TOX DUST. IN A MFR SPONSORED CHRONIC
    INHAL STUDY IN RATS USING SPECIAL TEST TONER, THERE WERE NO LUNG
    CHANGES @ ALL IN THE LOWEST EXPOS  LEVEL (1 MG/M3), THE MOST
    RELEVANT LEVEL TO POTENTIAL HUMAN EXPOS. VERY SLIGHT DEGREE OF
    FIBROSIS WAS(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:NOTED IN 25% OF ANIMALS @ THE MIDDILE
    EXPOS LEVEL (4 MG/M3) WHILE A SLIGHT DEGREE OF FIBROSIS WAS
    OBSERVED @ THE HIGHEST EXPOS LEVEL (16 MG/M3) IN ALL ANIMALS. THESE
    FINDING ARE ATRIBUTED TO  "LUNG OVER-LOADING," A GENERIC RESPONSETO
    EXCESS AMTS OF ANY DUST RETAINED IN LUNGS FOR A PRLNGD INTERVAL.
    (SUPP DATA)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:EYE: FLUSH WITH WATER FOR AT LEAST 15 MIN. SKIN: WASH WITH
    SOAP AND WATER. INHAL: REMOVE FROM EXPOSURE. INGEST: DILUTE STOMACH
    CONTENTS WITH SEVERAL GLASSES OF WATER.

=====================  Fire Fighting Measures  =====================

Extinguishing Media:WATER, DRY CHEMICAL, CARBON DIOXIDE OR FOAM.
Fire Fighting Procedures:AVOID INHALATION OF SMOKE. WEAR NIOSH/MSHA
    APPROVED SCBA AND FULL PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:TONER IS COMBUSTIBLE POWDER. LIKE MOST
    ORGANIC MATERIALS IN POWDER FORM, WHEN DISPERSED IN AIR, IT CAN
    FORM EXPLOSIVE MIXTURES.

==================  Accidental Release Measures  ==================

Spill Release Procedures:SWEEP UP/VACUUM SPILLED TONER & CAREFULLY
    TRANSFER INTO A SEALABLE WASTE CNTNR. SWEEP SLOWLY TO AVOID MAKING
    LOOSE TONER AIRBORNE. IF VACUUM IS USED, THE MOTOR MUST BE RATED AS
    DUST TIGHT. A CONDUCTIV E HOSE BONDED TO THE MACHINE SHOULD (SUPP
    DATA)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:USE WITH ADEQUATE VENTILATION.
Other Precautions:AVOID PROLONGED INHALATION OF EXCESSIVE DUST.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:NONE REQUIRED WHEN USED AS INTENDED. NIOSH/MSHA
    APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN .
Ventilation:NONE SPECIFIED BY MANUFACTURER.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES 
Other Protective Equipment:FOR USE OTHER THAN NORMAL CUSTOMER-OPERATING
    PROC (SUCH AS BULK TONER PROCESSING FACILITIES), GOGG/RESP MAY BE
    REQUIRED.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EFTS OF OVEREXP:SPECIAL TEST TONER WASH 10X MORE RESP THAN COMMERCIALLY
    AVAIL MFR'S TONER TO COMPLY W/EPA TESTING PROTOCOL & WOULD NOT
    FUNCTION PROPERLY IN MFR'S EQUIP.SPILL PROC:BE USED TO REDUCE STA
    TIC BUILDUP.RESIDUE CAN BE REMOVED W/SOAP & COLD WATER.GARMENTS MAY
    BE WASHED/DRY CLEANED, AFTER REMOVAL OF LOOSE TONER.

==================  Physical/Chemical Properties  ==================

HCC:N1
Spec Gravity:1.7 (H*2O=1)
Solubility in Water:NEGLIGIBLE
Appearance and Odor:BLACK POWDER/FAINT ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:PRODUCTS OF COMBUSTION MAY BE TOXIC.
    AVOID BREATHING SMOKE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE,
    AND LOCAL REGULATIONS. INCINERATE ONLY IN A CLOSED CONTAINER.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.